Table of Contents
Advertisement
82 BODY MANUAL
6. Install valance panel by inserting lower flange between
door and pocket trimboard with slots in line with the
trimboard clips. Force down into position and install
screws.
7. Install arm rest, garnish moulding, lock release knob,
and window regulator switch.
QUARTER TRIM PANEL
The quarter trim panel consists of two separate panels; the
forward (triangular) panel is held in place by two screws
(B), Figure 130, under the garnish moulding (A) and two
screws (C) and countersunk washers at the door pillar. A
clip at the rear of the panel enters behind the rear half of
the quarter trim panel.
FIGURE 130
REMOVAL:
To remove the front half of the quarter trim panel, remove
the garnish moulding (A), screws (B) and (C), and switch
or regulator handle (D), Figure 130.
To remove the rear half of the quarter trim panel, proceed
as follows:
1. Remove rear seat cushion.
2. Remove garnish moulding (A) and screws (E).
3. Remove rear seat back.
4. Remove two screws (I) from bracket in seat back.
5. Snap bottom trim strip from base of quarter panel and
remove screw (H)
6. Raise rear corner of trim panel facing and remove
screws (F) and (G).
7. Remove screw behind panel. This screw is located
under the carpet that covers the pillar to wheelhouse brace.
INSTALLATION:
To install, reverse procedure of removal.
FRONT SEAT CUSHION AND
SEAT BACK
REMOVAL:
1. Remove front seat cushion by raising front of cushion
slightly and pulling cushion up and out.
2. Remove the four bolts attaching the bottom of front seat
frame to seat track. 3. Remove two screws attaching seat
adjusting lever to seat frame and remove seat back from
car.
INSTALLATION:
To install, reverse procedure of removal.
REAR SEAT CUSHION AND
SEAT BACK
REMOVAL:
1. Rear seat cushion is removed by lifting the forward
edge and pulling the seat cushion forward.
2. Removal of seat exposes four hex head screws at bot-
tom of seat back. Remove these screws.
3. Remove two Phillips head screws from each side of the
top of the back at rear quarter trim panel support and
remove seat back.
INSTALLATION:
To install, reverse procedure of removal.
DOOR OUTSIDE HANDLE
To remove the door outside handle, remove Phillips head
screw (A), Figure 131, from edge of door. Push handle
forward and lift handle out of door.
To install, reverse procedure of removal.
Advertisement
Table of Contents
