Door Lock - Hudson 480-490 Series Service Manual

FIGURE 28
INSTALLATION:
Reverse procedure of removal and repair damage to door
inner liner with Mystik tape.
FIGURE 29
DOOR WINDOW REGULATOR
REMOVAL:
1. Remove trim panel. See page 28.
2. Remove garnish moulding spacer wood block.
3. Cut door inner liner as shown in Figure 29.
(Rear)
BODY MANUAL
4. Remove 4 screws (A) holding regulator to door inner
panel.
5. Lower window to bottom of door and release regulator
from glass channel. 6. Remove regulator through opening
at bottom of door.
INSTALLATION:
Reverse procedure of removal and repair damage to door
inner liner with Mystik tape.
FIGURE 30

DOOR LOCK

(Front and Rear)
REMOVAL:
1. Remove outside door handle.
2. On front doors, remove door lock cylinder.
3. Remove door trim panel. See page 28.
4. Cut door inner liner at (A), Figure 30, front door; or
Figure 31, rear door, and disconnect remote control arm
from lock at D.
5. Remove window channel from lock side of door.
6. Remove three large Phillips head screws (C) from edge
of door and remove lock assembly down and out through
lower opening in door inner panel.
INSTALLATION:
Reverse the procedure for removal. Repair any damage to
inner liner with Mystik tape.
29