Hudson 480-490 Series Service Manual page 43

9. Before locking the receiver securely in position, place
the instrument finish panel into position over the clock
and note whether or not the radio and trim panel are
centered correctly. If not, move the radio until the dash
trim panel and radio dial escutcheon assembly are in
alignment. Then permanently fasten set in position by
tightening the two front screws and the nut and bolts on
FIGURE 35
FIGURE 34
the rear mounting bracket. Replace instrument finish
panel and fasten securely.
10. Connect the "A" lead of the set to the battery terminal
of the circuit breaker, Figure 34, mounted on the instru-
ment panel brace over the steering column (Figure 35).
11. Plug in antenna cable (Figure 36).
12. Remove speaker cover plate, and pull speaker leads
through opening in dash.
13. Plug speaker leads into pin socket mounted on speak-
er. Make sure green wire plugs into green spotted pin
socket.
14. Lower speaker into position, and line up with holes in
the instrument panel. Place speaker grille, included in
radio package:, over speaker, making sure the mounting
holes line up; then fasten securely with the four chrome
plated screws provided in kit.
15. Place tone control knob onto shaft; put on volume
control knob, and tighten set screw (Figure 34). Be sure
there is no binding.
16. Place knob tension spring over the tuning shaft. Put on
trim ring and press on tuning control knob as far as it will
go. Tighten set screw (Figure 34).
17. Replace ornament and door.
BODY MANUAL 37