Hudson 480-490 Series Service Manual page 85

FIGURE 120
REAR QUARTER WINDOW
REGULATOR ASSEMBLY
REMOVAL:
1. Remove rear seat cushion and rear seat back. See Page
82.
2. Remove all rear quarter panel trim on side on which
work is to be performed. See Page 82.
3. Remove the windlace and tacking strips as a unit.
Tacking strip is retained by two clips (A), Figure 121.
4. Remove screws (B) and one Phillips head screw (C)
and quarter inner panel (G).
FIGURE 121
5. Remove quarter window pivot bolt (D) and three (3)
hex head cap screws (E) from quarter window regulator.
Disconnect hydraulic inlet-outlet tube (F) and solenoid
lead wire and lift window and regulator assembly up and
out of top of quarter panel.
NOTE: Manually operated regulator may be removed
without removing quarter inner panel. With window
removed, remove cap screw (B) and spring panel out
until regulator may be lifted out.
WINDOW OPERATING SWITCHES
The double acting electrical window operating switches
are provided with three terminal posts, each marked to
indicate the correct wire connections. The operating knob
is self centering and must be mounted so that there is no
interference with the free movement of the knob.
FIGURE 122
Figure 122 shows the position of the knob in the neutral
position.
FIGURE 123
Figure 123 shows the knob in the window raising position.
BODY MANUAL 79