Table of Contents
Advertisement
34 BODY MANUAL
INSTRUMENT SWITCH PANEL
REMOVAL:
1. Remove starter switch (3), Figure 32.
2. Remove left half of chrome finish strip at steering
column.
3. Remove
Phillips head screw from
left end
el and one from the underside at right end.
4. Remove one 3/8 nut from bolt in top of panel. Bolt
extends under locker box. 5. Remove panel and orna-
ment (D).
INSTALLATION:
Reverse procedure of removal.
INSTRUMENT SWITCH PANEL
NOTE: Disconnect negative battery cable at bat-
tery before removing switches.
REMOVAL:
1. Remove ignition switch (27), Figure 32.
2. Remove instrument lamp rheostat (29).
3. If car is equipped with Drive-master, remove
Drivemaster control switch (30).
4. Remove light switch (32).
5. Remove cigar lighter (33).
6. Remove windshield wiper control (36).
7. Remove three screws from the underside of switch
panel and one from the right end of the panel.
8. Upper edge of panel is attached to instrument panel
by three bolts; one is located under the locker box,
one under the radio, and one under the inner corner of
the glove compartment. Remove the nuts from these
bolts using a 3/8" socket and extension.
9. Remove right hand half of chrome finish strip (G)
at steering column.
10. Remove switch panel (E) and panel ornament (F).
INSTALLATION:
Reverse procedure of removal.
(Left)
(Right)
INSTRUMENT FINISH PANEL
REMOVAL:
1. Remove ornamental trim.
2. Remove locker box and glove compartment door bum-
pers.
3. Remove two screws from each end of finish panel.
Screws are exposed when glove-compartment and locker
box doors are open. On models not equipped with locker
box, remove screw from inside upper edge of left section
of finish panel to release hinged panel and expose_
screws. On earlier models three screws hold this section
of the panel in place.
NOTE: On radio equipped cars it is necessary to re-
move control knobs and escutcheon nuts.
INSTALLATION:
Reverse procedure of removal.
SPEEDOMETER
REMOVAL:
1. Remove instrument finish panel (A). Figure 32.
2. Remove four screws attaching speedometer to instru-
ment panel and remove speedometer from panel.
3. Pull the beam indicator and instrument lamps and
sockets from the speedometer and unscrew the cable.
INSTALLATION:
Reverse procedure of removal.
CLOCK
REMOVAL:
1. Remove instrument finish panel (A), Figure 32.
2. Remove four screws attaching clock to instrument
panel and remove clock (39) from panel.
3. Pull the instrument lamp and socket from the clock.
4. On electric clocks, disconnect feed wire at fuse connec-
tor.
INSTALLATION:
Reverse procedure of removal.
Advertisement
Table of Contents
