Table of Contents
Advertisement
22 BODY MANUAL
RADIATOR
REMOVAL:
1. Drain radiator and disconnect hoses.
2. Remove two sheet metal screws attaching deflector shield
to fender tie panel.
3. Remove headlight wiring from retaining clips at the front
of radiator.
4. Remove 4 hex head bolts attaching radiator to "U" channel
and remove radiator.
INSTALLATION:
Reverse procedure of removal.
RADIATOR "U" CHANNEL WITH
RADIATOR REMOVED
REMOVAL:
1. Remove headlight junction blocks; leave wires attached.
2. Remove two attaching bolts (each side) from radiator
mounting channel to fender.
3. Remove attaching bolts from mounting channel to fender
tie panel.
4. Remove the bolt attaching the bottom of mounting channel
to frame front cross-member. Remove channel from car.
INSTALLATION:
Reverse procedure of removal.
RADIATOR GRILLE BAFFLE
(UPPER)
(Right or Left)
REMOVAL:
1. Remove center support bar moulding.
2. Remove screw at front and rear of center bar.
3. Remove one screw from under fender and one screw at
grille baffle side supports. Remove baffle from car.
INSTALLATION:
Reverse procedure of removal.
RADIATOR SPLASH GUARD
(Right or Left)
REMOVAL:
NOTE: The splash guard consists of two pieces joined at
center support. Either right or left side may be removed
separately.
1. Remove complete front bumper assembly.
2. Remove three bolts at each side attaching splash
guard to radiator grille panel.
3. Remove bolt at grille lower center bar and the bolt
attaching center plate to right and left hand splash guard.
4. Slide splash guard out.
INSTALLATION:
Reverse procedure of removal.
RADIATOR FRONT SPLASH
GUARD AND MOULDING
REMOVAL:
1. Remove front bumper center grille guard.
2. Remove one bolt (each side) attaching front splash
guard (center) to front fender and lower splash guard.
3. Remove two brass nuts and clips (each side) under
fender attaching fender to splash guard moulding.
4. Remove bolt attaching splash guard to grille lower
center bar and remove splash guard.
INSTALLATION:
Reverse procedure of removal.
RADIATOR GRILLE CENTER BAR
(UPPER)
REMOVAL:
1. Remove two screws and remove the center bar
support moulding.
2. Remove bolts attaching grille baffles to center bar.
3. Remove two bolts attaching center bar to fender tie
panel and to front splash guard.
4. Remove center support and splash guard center plate.
Remove bar from car.
INSTALLATION:
Reverse procedure of removal.
Advertisement
Table of Contents
