Table of Contents
Advertisement
12.7
Checking the static sag of the shock absorber
12.8
Checking the riding sag of the shock absorber
–
Measure dimension
–
Hold the motorcycle upright with the aid of an assistant.
–
Measure the distance between the rear axle and the fixed point
again.
–
Note down the value as dimension
Info
The static sag is the difference between
measurements
–
Check the static sag.
Static sag
»
If the static sag is less or more than the specified value:
–
Adjust the spring preload of the shock absorber.
(
p. 52)
400989-10
–
Measure dimension
–
With another person holding the motorcycle, the rider, wear-
ing full protective clothing, sits on the seat in a normal sitting
position (feet on footrests) and bounces up and down a few
times.
The rear wheel suspension levels out.
–
Another person now measures the distance between the rear
axle and the fixed point.
–
Note down the value as dimension
Info
The riding sag is the difference between
measurements
–
Check the riding sag.
Riding sag
»
If the riding sag differs from the specified measurement:
–
Adjust the riding sag.
400990-10
TUNING THE CHASSIS 12
A
of rear wheel unloaded. (
B
.
A
B
and
.
30 mm (1.18 in)
A
of rear wheel unloaded. (
C
.
A
C
and
.
90 mm (3.54 in)
(
p. 53)
p. 50)
p. 50)
51
Advertisement
Table of Contents
Troubleshooting
