30/DISASSEMBLING THE ENGINE
Removing crankshaft and balancer shaft
18.31
Removing transmission shafts
18.32
–
Install the special tool
Extractor (75029048000) (
Info
Use the 750 drill hole.
–
Pull off the section of the engine case.
Info
300076-10
Do not tension the section of the engine case.
The balancer shaft and the main shaft have a stop disk, these usually stick
to the bearing.
–
Take off the left section of the engine case.
–
Remove the special tool.
–
Remove dowels.
–
Remove O-ring
300077-10
–
Remove the crankshaft
300078-10
–
Remove the shift rail
300079-10
–
Swing shift forks
–
Remove shift drum
300080-10
with suitable screws.
p. 251)
.
and the balancer shaft
.
to one side.
.
.
120