Removing Timing Chain And Timing Chain Sprocket; Removing Crankshaft Position Sensor; Removing Clutch Cage - KTM 690 Enduro EU 2009 Repair Manual

30/DISASSEMBLING THE ENGINE

Removing timing chain and timing chain sprocket

18.21

Removing crankshaft position sensor

18.22

Removing clutch cage

18.23
–
Hold the timing chain securing guide tight and pull the timing chain tensioning
rail out of the timing chain securing guide.

–
Take out the timing chain tensioning rail upwards through the chain shaft.
–
Remove the timing chain securing guide
300046-10
–
Unthread the timing chain.
Info
Mark the direction of travel.
–
Take off the lock ring
300148-10
–
Pull of the timing chain sprocket with the special tool
Extractor (59029033000) (
300149-10
–
Remove the screws of crankshaft position sensor
–
Pull cable support sleeve
tion sensor.
300151-10
–
Compress the antihopping clutch with the special tool
Assembly screws (75029033000) (
Info
Apply the special tool with the hand only, do not use another tool.
300051-10
.

.

p. 247)

out of the engine case. Take off the crankshaft posi-

p. 250)
116
.

.
.
