Changing Fuses Of Individual Power Consumers - KTM 690 Enduro EU 2009 Repair Manual

11/WIRING HARNESS, BATTERY

Changing fuses of individual power consumers

14.8
Info
The fuse box containing the fuses of individual power consumers is located under the seat.
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
–
Remove protection covers
600604-10
–
Remove a defective main fuse
–
Install a new main fuse.
Fuse (58011109130) (
Info
A reserve fuse
–
Check that the electrical equipment is functioning properly.
–
Mount the protection covers.
600605-10
–
Mount the seat. (
–
Set the clock. (
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
–
Open fuse box cover
600604-11
–
Remove the defective fuse.
Guideline
Fuse 1 - 10A - ignition, combination instrument
Fuse 2 - 10A - clock, ignition (EFI control unit)
Fuse 3 - 10A - throttle valve control unit
Fuse 4 - 10A - fuel pump
Fuse 5 - 10A - radiator fan
Fuse 6 - 10A - horn, brake light, turn signal
Fuse 7 - 15A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 8 - 10A - for supplementary equipment (accessories connected with igni-
tion switch)
Fuse 9 - 10A - for accessories (permanent positive)
Fuse 10 - not used
Fuse SPARE - 10A/15A - spare fuses
Info
A defective fuse is shown by a burned-out fuse wire
600606-10
p. 66)
.

with needle nose pliers.

p. 191)
is located in the starter relay.

p. 66)
p. 96)
p. 66)
.

84
.
