Customising The Buttons; Xn120 Getting Started Guide - NEC XN120 Getting Started Manual

Customising the buttons

When a console is installed the 64 buttons are automatically assigned as Direct Station Select (DSS) keys for
extensions 200 to 263.
You can customize the buttons of each console with program 30-03-01.
The buttons can have the same functions as the programmable keys on the XN120 system phones. This
section will show the setting of the DSS function. For other functions refer to the XN120 Programming
Reference Manual 991435-5.
Program 30-03-01
Customise the buttons.
Each button has two entries:
Function code and Additional
data.
The 64 buttons are shown as
KY01 to KY64.
This guide shows function
code 01 for DSS function.
The additional data can be up
to 36 digits long and can be
any number including outside
numbers.
For outside numbers enter the
trunk access code followed by
the number to dial out
e.g. 901509643100

XN120 Getting Started Guide

Appendix A – 64 Button Consoles
Default Setting:
The 64 buttons are set as DSS function for extensions 200 to 263.
30-03-01
KY01=01
Enter the Function Code.
01 for DSS function
Ø Enter the Function Code, 01 for DSS function; you can
overwrite the current entry. Enter 000 to set the key to 'Not
Defined'.
Ø Press HOLD to confirm the entry and step to the Additional
Data.
30-03-02
KY01=AD 200
Enter the telephone number that
will be assigned to the button
Ø Enter the additional data for the key. This will determine the
telephone number that will be assigned to the button.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
Use Vol. Keys to
select another
DSS 1
DSS console
(1-9)
DSS 1
63