Configuration Settings Using The Cli - Polycom BelAir50 Configuration Manual

Configuration Settings Using the CLI

6
The following table contains the configuration parameters
recommended for interoperability with SpectraLink 8000 Wireless
Telephones.
Mode: AP
SVP: Enable
Voice SSID: Map to VLAN 100
QoS mapping: Map VLAN 100 to queue 3
Antenna Diversity: Enable
BelAir access radios implement SVP. BelAir backhaul radios can use
VLANs to assign voice priority to SpectraLink traffic or they can use
the 802.1p User Priority field to prioritize traffic.
The configuration shown above uses VLAN prioritization. Any
VLAN ID can be used. In the sample configuration given throughout
this document, we chose a VLAN ID of 100.
Telnet to CLI
The following command is used to telnet to CLI.
telnet <IP address of controller>
Check the software version
The following commands display the installed loads and the active
load.
/# cd /system
/system# show loads
/system# show active load
Enable radio
The following command enables the access radio.
/radio# set arm1 mode ap
Check access configuration
The following commands display the general configuration of the
access radio.
/# cd /radio
/radio# show arm1 config
Configuration Guide
PN: 1725-36065-001_D.doc