Set Antenna Diversity; Disable Wmm; Save The Configuration - Polycom BelAir50 Configuration Manual

Configuration Guide
Set WPA2-PSK for access
The following commands enable/disable the WPA2-PSK for the voice
SSID (ssidx 2).
/# cd /radio
/radio# set arm1 wpa2 psk <Pre-Shared Key> ssidx 2
enabled
/radio# set arm1 wpa2 ssidx 2 disable

Set antenna diversity

The following commands enable antenna diversity.
/# cd /radio
/radio# set arm1 rcv antenna diversity enabled
Enable SVP
The following commands enable SVP support.
/# cd /qos
/qos# set svp enable

Disable WMM

The following commands disable WMM support.
/# cd /radio
/radio# set wmm disable
Map VLAN to QoS
The following commands map the voice VLAN (such as VLAN 100, in
the example) to queue 3, which is the highest priority queue.
SpectraLink 8000 Wireless Telephones must always be assigned to
queue 3.
/# cd /qos
/qos# map vlan id 100 to queue 3
/qos# show vlan all qos config

Save the configuration

The following command saves the AP's current configuration so that
it will be used after reboot.
/# config-save
8
PN: 1725-36065-001_D.doc