Configuration Independent Prime 1 Through 8 Menu - Comtech EF Data SMS-7000 Installation And Operation Manual

Modem protection switch
Table of Contents

Advertisement

SMS-7000 Modem Protection Switch
3.4.2

Configuration Independent Prime 1 through 8 Menu

Refer to Figure 3-4.
PRIME MODEM #n
ADDRESS
PRIME MOD #n
PRIME MOD #n
PRIORITY
PRIME MOD #n DELAY
PRIME DEMOD #n
PRIME DEMOD #n
PRIORITY
PRIME DEMOD #n
DELAY
PRIME #n
MULTIPLEXER
PRIME DEMOD #n
MULTIPLEXER
ADDRESS
(Menu applies, only if
multiplexer is attached.)
Rev. 3
Set # other than 0. Address 0 is a global address which is used to
communicate with all modems even though the address is set to
something else.
Address: 0 to 255
Upon entry, the current status is displayed. Press [↑] or [ ↓] to make
the selection. Press [ENTER] to execute the change.
Must be On for the switch to recognize it as active.
Upon entry, the current status is displayed. Press [↑] or [ ↓] to make
the selection. Press [ENTER] to execute the change.
Options: LOW, MEDIUM, and HIGH.
Upon entry, the current status is displayed. Press [↑] or [ ↓] to make
the selection. Press [ENTER] to execute the change.
NONE
MANUAL = 0.5 to 127.0 SEC.
Upon entry, the current status is displayed. Press [↑] or [ ↓] to make
the selection. Press [ENTER] to execute the change.
Must be On for the switch to recognize it as active.
Upon entry, the current status is displayed. Press [↑] or [ ↓] to make
the selection. Press [ENTER] to execute the change.
Options: LOW, MEDIUM, and HIGH.
Upon entry, the current status is displayed, Press [↑] or [ ↓] to make
the selection. Press [ENTER} to execute the change.
NONE
AUTO
MANUAL = 0.5 to 127.0 SEC.
Upon entry, the current status is displayed. Press [↑] or [ ↓] to make
the selection. Press [ENTER] to execute the change.
Displayed if multiplexer is; 'YES or NO.'
Upon entry, the current status is displayed. Press [↑] or [ ↓] to make
the selection. Press [ENTER] to execute the change.
Set # other than 0. Address 0 removes the multiplexer from the
system.
Address: 0 to 255
Upon entry, the current status is displayed. Press [↑] or [ ↓] to make
the selection. Press [ENTER] to execute the change.
Operation
3–11

Advertisement

Table of Contents
loading

Table of Contents