Table of Contents
Advertisement
SMS-7000 Modem Protection Switch
Rev. 3 Draft
Bit 0 = No prime demodulator configuration loaded fault.
Character 's': Prime #2 system fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime not assigned to backup fault.
Bit 4 = Prime multiplexer communications failure fault.
Bit 3 = No address for prime multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character 't': Prime #2 system fault status character 3.
Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #2 system stored faults.
Character 'u': Prime #3 system fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modem communications failure fault.
Bit 4 = Prime modulator configuration verify error fault.
Bit 3 = Prime demodulator configuration verify error fault.
Bit 2 = No address for prime fault.
Bit 1 = No prime modulator configuration loaded fault.
Bit 0 = No prime demodulator configuration loaded fault.
Character 'v': Prime #3 system fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime not assigned to backup fault.
Bit 4 = Prime multiplexer communications failure fault.
Bit 3 = No address for prime multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character 'w': Prime #3 system fault status character 3.
Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #3 system stored faults.
Character 'x': Prime #4 system fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modem communications failure fault.
Bit 4 = Prime modulator configuration verify error fault.
Bit 3 = Prime demodulator configuration verify error fault.
Bit 2 = No address for prime fault.
Bit 1 = No prime modulator configuration loaded fault.
Bit 0 = No prime demodulator configuration loaded fault.
Character 'y': Prime #4 system fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime not assigned to backup fault.
Bit 4 = Prime multiplexer communications failure fault.
Bit 3 = No address for prime multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character 'z': Prime #4 system fault status character 3.
Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #4 system stored faults.
Remote Control Operation
A–17
Advertisement
Table of Contents
