Switch - Comtech EF Data SMS-7000 Installation And Operation Manual

Remote Control Operation
Prime Command:
Demodulato Response:
r On-line
Delay Status:
Response:
Prime Command:
Modem On- Response:
line Delay
Status:
Response:
Prime Command:
Multiplexer Response:
Unit
Attached Status:
Response:
Prime Command:
Multiplexer Response:
Unit
Address Status:
Response:
A.3.3

Switch

Load Command:
Backup Response:
Modem X
Load Command:
Prime Response:
Modem X
Load All Command:
Modems Response:
Verify Command:
Backup Response:
Modem X
A–8
<add/DD_x_yyy.y'cr'
>add/DD_x_yyy.y'cr''lf']
<add/DD_x'cr'
>add/DD_x_yyy.y'cr''lf']
<add/MD_x_yyy.y'cr'
>add/MD_x_yyy.y'cr''lf']
<add/MD_x'cr'
>add/MD_x_yyy.y'cr''lf']
<add/MU_x_yyy'cr'
>add/MU_x_yyy'cr''lf']
<add/MU_x'cr'
>add/MU_x_yyy'cr''lf']
<add/MUA_x_yyy'cr'
>add/MUA_x_yyy'cr''lf']
<add/MUA_x'cr'
>add/MUA_x_yyy'cr''lf']
<add/LMC_Bx'cr'
>add/LMC_Bx'cr''lf']
<add/LMC_x'cr'
>add/LMC_x'cr''lf']
<add/LMC_ALL'cr'
>add/LMC_ALL'cr''lf']
<add/VMC_Bx'cr'
>add/VMC_Bx'cr''lf']
SMS-7000 Modem Protection Switch
Where:
x = 1 to 8 (prime modem demodulator number).
NONE, AUTO, or MANUAL.
yyy.y = 0.5 to 127.0 seconds (in 0.5 second increments).
Notes:
1. If AUTO is selected, switching occurs after a delay
period of 2.5 minutes.
2. If MANUAL is selected, enter the number of seconds for
the delay period.
3. Independent switching mode.
Where:
x = 1 to 8 (prime modem number).
yyy.y = 0.5 to 127.0 seconds (in 0.5 second increments),
NONE, or AUTO.
Notes:
1. If AUTO is selected, the delay is two times the sweep
period.
2. Dependent switching mode.
Where:
x = 1 to 8 (prime multiplexer number).
yyy = YES or NO.
Where:
x = 1 to 8 (prime multiplexer number).
yyy = 0 to 255 (Prime multiplexer address; 0 places prime
multiplexer out of service).
Where: x = 1 or 2 (backup modem number).
Note: Status can be polled after operation by using the MNF_
or BCSF_ commands.
Where: x = 1 or 8 (prime modem number).
Note: Status can be polled after operation by using the MNF_
command.
Notes:
1. This command will load all active backup modem and
prime modem configurations.
2. Status can be polled after operation by using the MNF_
command.
Where: x = 1 or 2 (backup modem number).
Note: Status can be polled after operation by using the MNF_
command.
Rev. 3 Draft