End Character - Comtech EF Data SMS-7000 Installation And Operation Manual

SMS-7000 Modem Protection Switch
Notes:
A.2.3

End Character

Each message is ended with a single character which signals the end of the message.
This character is:
•
•
Rev. 3 Draft
1. "add" is used to indicate a valid 1 to 3 character device address in the range
between 1 and 255.
2. The switch does not respond to erred communications (i.e., parity and
framing errors).
"cr"
Carriage return character for commands
"]"
End bracket for responses
Remote Control Operation
A–5