Status Commands/Responses - Comtech EF Data SMS-7000 Installation And Operation Manual

SMS-7000 Modem Protection Switch
A.4

Status Commands/Responses

Backup Command:
Modulator Response:
Config.
Status
Backup Command:
Demodulato Response:
r Config.
Status
Prime Command:
Modulator Response:
Config.
Status
Rev. 3 Draft
<add/MCS_Bn'cr'
>add/MCS_Bn'cr'
MA_xxx'cr'
ADD_mmm'cr'
SM_xxx'cr'
PMA_mmmmmmmm'cr'
MU_xxx'cr'
MUA_mmm'cr''lf'] (See Note)
<add/DCS_Bn'cr'
>add/DCS_Bn'cr'
DA_xxx'cr'
ADD_mmm'cr'
SM_xxx'cr'
PMA_mmmmmmmm'cr'
MU_xxx'cr'
MUA_mmm'cr''lf'] (See Note)
<add/MCS_n'cr'
>add/MCS_n'cr'
MA_yyy'cr'
MP_y'cr'
MD_yyy.y'cr'
ADD_mmm'cr'
MU_xxx'cr'
MUA_mmm'cr' (See Note)
DID_xxxxx'cr'
ECLK_xxxxx'cr'
IDI_xxxx'cr''lf']
Where: n = 1 or 2 (backup modem number).
Modulator Active (YES/NO)
Modem Address
Switching Mode (IND/DEP)
Prime Modem Assignments
Multiplexer Unit Attached (YES/NO)
Multiplexer Unit Address
The backup modulator configuration status command
causes a block of data to be returned by the SMS-7000. The
block of data reflects the stored configuration of the backup
modem selected.
Note: Status only returned if multiplexer unit attached.
Where: n = 1 or 2 (backup modem number).
Demodulator Active (YES/NO)
Modem Address
Switching Mode (IND/DEP)
Prime Modem Assignments
Multiplexer Unit Attached (YES/NO)
Multiplexer Unit Address
The backup demodulator configuration status command
causes a block of data to be returned by the SMS-7000. The
block of data reflects the stored configuration of the backup
modem selected.
Note: Status only returned if multiplexer unit is attached.
Where: n = 1 to 8 (prime modem number).
Modulator Active (YES/NO)
Modulator/Modem Priority
Modulator/Modem Delay
Modem Address
Multiplexer Unit Attached (YES/NO)
Multiplexer Unit Address
Drop & Insert Data (BAL/UNBAL)
External Clock (BAL/UNBAL)
Insert Data Input (LOOP/NORM)
The prime modulator configuration status command causes
a block of data to be returned by the SMS-7000. The block
of data reflects the stored configuration of the prime modem
selected.
Note: Status only returned if multiplexer unit is attached.
Remote Control Operation
A–11