Magnetic Stripe Reader; Attaching And Removing The Msr; Using The Msr - Motorola MC9500-K Integrator Manual

Magnetic Stripe Reader

This section describes how to set up and use the snap-on Magnetic Stripe Reader (MSR) with the MC9500-K. The
MSR snaps on to the back of the MC9500-K and removes easily when not in use.
When attached to the MC9500-K, the MSR allows the MC9500-K to capture data from magnetic stripe cards. To
download sample MSR data capture software, visit http://www.motorola.com/enterprisemobility/support.
NOTE The MSR provides pass-through charging so that the MC9500-K can be changed while MSR is attached and
connected to a cradle or cable.
While charging, the MSR functionality is disabled.
When hooking the MC9500-K with MSR onto a four bay cradle, remove the guide cup before using.

Attaching and Removing the MSR

Align and hook the MC9500-K interface pocket onto the MSR's cleat.
Release Button
MSR Installation
Figure 2-38
To remove the MSR press the release button and remove the MSR from the MC9500-K.

Using the MSR

The MSR3000 sample application illustrates how an application handles MSR inputs (refer to Motorola Enterprise
Mobility Applications User's Guide).
To use the MSR:
Attach the MSR to the MC9500-K.
1.
Power on the MC9500-K.
2.
Tap >
3. Start Samples.C
Card Reader Slot
> to start the sample application.
MSR
Accessories 2 - 27