Network Settings - Yealink SIP-T4X Administrator's Manual

Administrator's Guide for SIP-T4X IP Phones
This section provides the sample configuration file necessary to configure the IP phone.
Any line beginning with a pound sign (#) is considered to be a comment, unless the # is
contained within double quotes. For Boolean fields, 0 = disabled, 1 = enabled.
This file contains sample configurations for the <y0000000000xx>.cfg or <MAC>.cfg file.
The parameters included here are examples only. Not all possible parameters are
shown in the sample configuration file. You can configure or comment the values as
required. The settings in the <y0000000000xx>.cfg file will be overridden by settings in
the <MAC>.cfg file.
T4X Sample Configuration File
#!version:1.0.0.1
#Note: This file header cannot be edited or deleted.

Network Settings

#
network.internet_port.type =
#Configure the WAN port type; 0-DHCP , 1-PPPoE, 2-Static IP Address.
#If the WAN port type is configured as DHCP , you do not need to set the following
network parameters.
#If the WAN port type is configured as Static IP Address, configure the following
parameters.
network.internet_port.ip =
network.internet_port.mask =
network.internet_port.gateway =
network.primary_dns=
network.secondary_dns =
#If the WAN port type is configured as PPPoE, configure the following parameters. It is
only applicable to SIP-T46G IP phone.
network.pppoe.user =
network.pppoe.password =
Dial Plan Settings
#
dialplan.area_code.code =
dialplan.area_code.min_len =
dialplan.area_code.max_len =
dialplan.area_code.line_id =
dialplan.block_out.number.1 =
dialplan.block_out.line_id.1 =
dialplan.dialnow.rule.1 =
dialplan.dialnow.line_id.1 =
450