Troubleshooting; Most Common Faults - Asko DW20.1 Service Manual

T R O U B L E S H O O T I N G T R O U B L E S H O O T I N G
T R O U B L E S H O O T I N G T R O U B L E S H O O T I N G T R O U B L E S H O O T I N G

6. Troubleshooting

If there are problems with poor washing results, you
must observe the following rules in the first instance:
• Use a suitable programme, such as Normal
programme 55°C/60°C for normally soiled
items. After week 16 2005, 55°C/65°C
Australia: 45°C/50°C. Not DW20.C, which
has a temperature of 55°C for a normal
program and Sani A (B).
• If more heavily soiled items are to be
washed, e.g. saucepans or gratin dishes,
select a stronger programme, such as
Heavy wash or Intensive wash.
• It is important to use a suitable detergent,
preferably one which has produced good
results in tests.
• You should not buy a bulk pack, because
detergent is a perishable product. The
detergent dose must also conform to the
recommendations on the pack. Above all,
avoid overdosing.
• In machines fitted with a water softener, set
the dispenser for soft water.
• The spray arms must not be obstructed and
they must rotate at the correct speed (12 -
25 r/min). Make sure that the machine takes
in the correct quantity of water; see the
user handbook.

6.1 Most common faults

If the dishwasher does not work, you should first
check whether this may be due to a simple fault
which the customer himself can correct. Identify
the fault with the help of the following questions.
Machine will not start
• Are the fuses intact?
• Is the machine connected to the mains?
• Is the door properly closed?
40
• Is the water tap open?
If you have answered "YES" to the above
questions, and if the machine appears to be
without a power supply, you should first check
that a power supply is present as far as the main
switch and as far as the control unit.
If the machine indicates that something is wrong,
e.g. "Open door" even though the door is closed,
check the door switch.
If the machine indicates "Overfilling", check the
overfilling system (microswitch, hoses, etc.)
Water remains in the machine
• Is there a blockage in the drain hose?
Check the connection at the union with the
building's drains.
• Is there a kink in the drain hose?
• Are the filters blocked?
• Is the drain pump blocked?
• Is the gauge block on the left in the sump
next to the drain pump incorrectly seated?
If you have answered "NO" to the above questions,
first check that the drain pump has a power supply
and that it is working. The pump must be replaced if
it is faulty. If there is no power supply to the pump,
check the output from the control unit. Replace the
control unit if it is defective.
The dishwasher is not clean
• Are the spray arms able to move freely?
• Are the holes in the spray arms free from dirt?
• Is the detergent being dispensed correctly?
Check that you are dispensing according to
the hardness of the water.
• Is the fine filter securely attached?
• Are you using the correct wash programme?
• Is the machine correctly loaded?