Installation; Freestanding & Built-In - Asko DW20.1 Service Manual

3. Installation

Recommended position for the dishwasher
The dishwasher can be installed as a built-in, fully
freestanding or half freestanding machine.
WARNING!
Connection to electricity, water and drains must
be carried out by a person with competence
within the respective area.
A. Built-in
The dishwasher can be built in under a worktop
with a working height of 820 - 870 mm.
(860 - 870 mm) = tall tank.
The width dimension must be at least 600 mm (see
Figure 1).
B. Freestanding
A freestanding machine must be provided with tilt
prevention means. This consists of two metal
brackets, which are screwed in place according
to the illustration (see Figure 2). An alternative to
this type of tilt prevention is a counterweight
installed directly on the rear of the machine.
Slide in the machine so that the metal brackets
engage with the rear feet. The machine now
cannot tilt if a load is placed on the open door. If
the machine is installed as a fully freestanding
machine, both side panels and the worktop should
be installed. These accessories can be purchased
where you purchased the dishwasher.
C. Half freestanding
If you position the machine so that one of the
sides is visible, you can install one side panel.
D. Machines with wooden door
Stronger door springs are available for purchase
for machines with a fitted wooden door. Springs
are available for various weights and sizes of
wooden door. Door springs can be purchased
from the retailer who sold you the dishwasher.
Built-in installation
820-870
(
860-870 )
Figure 1.
Freestanding installation
Figure 2.
WARNING!
A fully stand-alone machine must be provided
with tilt prevention/counterweight.
I N S T I N S TA L L A I N S T A L L AT I O N A L L A A L L A T I O N T I O N T I O N
I N S T I N S T A L L A T I O N
820-870
(
860-870 )
100-
150
15