Troubleshooting - Asko DBI564IXXLS U Series User Manual

Troubleshooting

Error messages
F10 Overfilling water 1
F11 Water outlet fault
F12 Water inlet fault 1
F40 Inlet valve leakage
F41 Heater fault 1
F45 Diverter fault
F52 Water level fault
F54 Overfilling water 2
F56 Circulation pump fault
F67 Water inlet fault 2
F68 BLDC drain pump fault
Press any button to clear the error message.
30
Action
Unblocking the drain pump. See the chapter Care and
maintenance instructions. If the problem persists, contact your
nearest Customer Care Center.
See "Water remains in the dishwasher above the filters" under
"Problem" in the table below. If the problem persists, contact your
nearest Customer Care Center.
Check that the water supply valve is on. If the problem persists,
contact your nearest Customer Care Center.
The water pressure should be 4.2-140 psi.
Turn off the water supply valve and contact your nearest Customer
Care Center.
Turn off the water supply valve. Remove the plug from the power
outlet and contact your nearest Customer Care Center.
Contact your nearest Customer Care Center.
Clean the coarse and fine filters. If the problem persists, contact
your nearest Customer Care Center.
Turn off the water supply valve and contact your nearest Customer
Care Center.
To avoid water leakage outside the dishwasher, do not remove
the plug from the power outlet until the water supply valve has
been turned off!
Contact your nearest Customer Care Center.
Check that the water supply valve is on. If the problem persists,
contact your nearest Customer Care Center.
The water pressure should be 4.2-140 psi.
See "Water remains in the dishwasher above the filters" under
"Problem" in the table below. If the problem persists, contact your
nearest Customer Care Center.