Programme Flow Description - Asko DW20.1 Service Manual

S E R V I C E M E N U S E R V I C E M E N U S E R V I C E M E N U S E R V I C E M E N U S E R V I C E M E N U

5.2 Programme flow description

Illustrated below is a normal programme (for EU ) and the sequence in which the various components arc
connected.
Normal wash
Component
Main wash
Drain pump
Inlet valve
Circulation pump
Pause
Circulation pump
Pause
Circulation pump
Pause
Circulation pump, Heater
Circulation pump
Pause
Circulation pump
Inlet valve, Circulation
Circulation pump, Combined dispenser
Circulation pump
Circulation pump, Heater
Circulation pump
Circulation pump, Heater
Circulation pump
Circulation pump
Drain pump
Circulation pump
Drain pump
* pulse = number of pulses from the flow sensor to obtain the given quantity of water
** applicable to a machine with spray arm dividers. In stage (with an additional circulation pump)
where no spray arm divider status is indicated, sequential 30 seconds lower arm low pressure, 30 seconds
ower arm high pressure, 30 seconds upper arm low pressure, 30 seconds upper arm high pressure are
intended.
*** without Spray arm dividers.
36
Commentary
25 sec
605 pulse*, 47 sec, 3.1 lit***
535 pulse* 40 sec, 2.7 lit**
30 sec, Upper arm high pressure**
1 sec
60 sec, Upper arm high pressure**
1 sek
120 sec, Upper arm high pressure**
1 sek
32°C, Temperature stop
5 min
3 sek
2 min, Upper arm high pressure **
75 pulse*, 6 sec, 0.4 lit
3 sec
3 min
40°C, Temperature stop
3 min
55°C
39 min
1 min, Upper arm high pressure**
2 sec SCS stage
20 sec SCS stage,Upper arm high pressure **
25 sec
l