Asko DW20.1 Service Manual page 18

I N S T I N S T A L L A A L L A T I O N T I O N
I N S T I N S T I N S TA L L A A L L A A L L AT I O N T I O N T I O N
8. Adjust the feet accurately (the machine
must not be inclined by more than five mm)
and tighten the locking nuts on the front feet.
To prevent kinking, pull on the drain hose and
connection pipe (see Figure 8).
Adjustment of plinth (only for models with a kick-
plate as an accessory)
The machine has two kick-plates.
Use the higher plate if the machine will be 850 -
870 mm high and the plinth depth can be varied
between 45 - 105 mm. Use the lower plate if the
machine will be 820 - 845 mm high. .
Secure the insulating mat supplied to the kick-plate.
Adjustment of right plinth depth
1. Move the grey hooks towards one another and
pull out the holders as far as required. Push in
the hooks so that they lock the holders
securely (see Figure 9).
2. Hang the kick-plate on the holders by
introducing it into the grooves.
Fitting fixed kick-plate
The machine is delivered with:
1. A height adjustable kick-plate.
2. Two screws.
(see Figure 10)
Screw the machine in place
If the machine is screwed on the sides, cover the
screw holes with the plastic plugs supplied.
Check after securing that the front feet are in
contact with the floor (see Figure 11).
18
Figure 8.
Figure 9.
Figure 10.
Figure 11.
1
2