Asko DW20.1 Service Manual page 17

Adjustiment of freestanding machine
1. Adjust the height of the machine with the
four steel feet. (see Figure 4)
NOTE! The machine must not be inclined
by more than 5 mm.
2. Lock the feet with the nuts.
3. After adjusting the steel feet, screw the two
rubber feet firmly to the floor.
The rubber feet now act as a tilt prevention
means. (see Figure 5)
Adjustment of machine with three or four feet
1. Begin by measuring the height from the
floor to the lower edge of the worktop.
2. Fit the sliding feet to the machine
(see Figure 6).
3. Measure the height from the floor to the top
edge of the machine.
4. Adjust all the feet by screwing them
clockwise to raise or anticlockwise to lower.
5. Check that the height of the machine
corresponds to the height from the floor to
the under side of the worktop. Tighten the
locking nuts on the rear feet.
6. Slide the machine into place.
7. Adjust the front feet accurately (the
machine must not be inclined by more than
5 mm) and tighten the locking nuts.
Adjustment of machine with adjustable foot
1. Begin by measuring the height from the
floor to the lower edge of the worktop.
2. Fit the sliding feet to the machine
(see Figure 6).
3. Measure the height from the floor to the top
edge of the machine.
4. Incline the machine forwards slightly and
adjust the rear foot roughly by screwing the
adjuster screw on the front clockwise to
raise or anticlockwise to lower (see Figure
7). Use a broad-bladed screwdriver or a
screwdriver with a hexagonal grip.
5. Adjust the front feet by rotating them
clockwise to raise or anticlockwise to lower.
6. Check that the height of the machine
corresponds to the height from the floor to
the under side of the worktop.
7. Slide the machine into place.
Figure 4.
Figure 5.
Figure 6.
Figure 7.
I N S T I N S T I N S TA L L A A L L A A L L A A L L AT I O N T I O N T I O N T I O N
I N S T I N S T A L L A T I O N
Stålfötter
Steel feet Steel feet Steel feet Steel feet Steel feet
Steel feet
17