User Password; Secure Boot - Aaeon MIX-ALND1 Manual

From the Create New Password box, key in a new password, then press
3.
<Enter>.
4. Confirm the password when prompted.
To clear the administrator password, follow the same steps as in changing an
administrator password, but press <Enter> when prompted to create/confirm the
password. After you clear the password, the Administrator Password item on top
of the screen shows Not Installed.
3.5.2

User Password

If you have set a user password, you must enter the user password for accessing
the system. The User Password item on top of the screen shows the default Not
Installed. After you set a password, this item shows Installed.
To set a user password:
Select the User Password item and press <Enter>.
1.
From the Create New Password box, key in a password, then press
2.
<Enter>.
3. Confirm the password when prompted.To change a user password:
To change a user password:
Select the User Password item and press <Enter>.
1.
From the Enter Current Password box, key in the current password, then
2.
press <Enter>.
From the Create New Password box, key in a new password, then press
3.
<Enter>.
4. Confirm the password when prompted.
To clear the user password, follow the same steps as in changing a user
password, but press <Enter> when prompted to create/confirm the password. After
you clear the password, the User Password item on top of the screen shows Not
Installed.
3.5.3

Secure Boot

Secure Boot feature is active when Secure Boot is set to [Enabled], Platform Key
(PK) is enrolled and the system is running in User mode. Changing the mode
requires platform reset. Configuration options: [Disabled] [Enabled]
Secure Boot Mode
Allows you to select Secure Boot Mode. When set to [Custom], Secure Boot Policy
variables can be configured by a physically present user without full authentication.
Configuration options: [Standard] [Custom]
Chapter 3: BIOS setup
3-13