Drive Coupling Removal And Installation; Flywheel Magneto Removal And Installation; Drive Coupling Check; Flywheel Magneto Check - Yamaha WaveRunner VX 700 Service Manual

Drive coupling removal and
installation
1. Remove the drive coupling.
Coupler wrench: 90890-06425
Flywheel holder: 90890-06522
Drive coupling:
36 N·m (3.6 kgf·m, 26.6 ft·lb)
TIP:
Install the drive coupling with the same spe-
cial service tools that were used for removal.
Flywheel magneto removal and
installation
1. Remove the flywheel magneto bolt.
Flywheel holder: 90890-06522
Flywheel magneto bolt:
74 N·m (7.4 kgf·m, 54.6 ft·lb)
TIP:
Install the bolt with the same special service
tool that was used for removal.
2. Remove the flywheel magneto. NOTICE:
To prevent damage to the engine or
special service tools, screw in the fly-
wheel puller set bolts evenly and com-
pletely so that the puller plate is
parallel to the flywheel magneto.
Flywheel puller: 90890-06521
TIP:
When installing the
degrease the flywheel magneto where it is
coupled to the crankshaft.

Drive coupling check

1. Check the drive coupling. Replace if
damaged or worn.

Flywheel magneto check

1. Check the ring gear. Replace if damaged
or worn.
Starter clutch assy.
flywheel magneto,
5-28
1
2
3
4
5
6
7
8
9
A