Yamaha WaveRunner VX 700 Service Manual page 145

Throttle cable removal
1. Remove the corrugated tube 1.
1
2. Remove the throttle cable 2. NOTICE:
Make sure to remove the throttle cable
seal a.
a
Handlebar check
1. Check the handlebar. Replace if bent,
cracked, or damaged.
Left handlebar switch assy. check
1. Check the left handlebar switch assy.
Replace if cracked or damaged.
TIP:
To check the continuity of the left handlebar
switch assy. See "Left handlebar switch
assy." (7-10).
Handlebar assy. installation
After installing the handlebar assy., make
sure that the throttle cable and left han-
dlebar switch lead are not pulled when the
handlebar is turned to the right and left.
1. Install the left handlebar switch lead 1
into the opening a in the grommet 2,
and then install the throttle cable 3 into
the opening a.
Left handlebar switch assy. and throttle lever assy.
TIP:
Face the chamfered end b of the grommet
2 down, with the opening a facing forward.
2. Install the grommet 2 into the steering
4
2
TIP:
Push the grommet 2 into the steering master
4 until it is installed securely.
3. Install the handlebar 5 and upper han-
3
a
b
master 4.
2
dlebar holders 6, and then tighten the
bolts 7 to the specified torque.
7
5
6
3
1
2
1
2
3
1
4
3
2
4
5
6
7
8
4
1
9
A
8-4