Yamaha WaveRunner VX 700 Service Manual page 76

POWR
Clearance a:
Less than 1.0 mm (0.039 in) (without
rubber damper)
Clearance b:
2.0–4.0 mm (0.079–0.157 in)
Available shim thicknesses:
0.10, 0.30, 0.50, 1.00, and 2.00 mm
5. Lift the engine unit slightly, remove the
shims 4, and then lower the engine unit.
6. Remove the engine mounting bolts 2
and washer 3.
7. Separate the engine unit from the engine
mounts and move it forward to discon-
nect the coupling.
8. Install the rubber damper 5.
9. Install the shims 4, and then adjust the
position of the engine unit so that the
coupling clearances a and b are within
specification.
10. Tighten the engine mounting bolts 2 to
the specified torque.
Engine mounting bolt 2:
17 N·m (1.7 kgf·m, 12.5 ft·lb)
5-7
Power unit
5
2
11. Check that the coupling clearances a
and b are within specification. Readjust
if out of specification.
a
Clearance a:
Less than 0.5 mm (0.039 in) (with
rubber damper)
Clearance b:
2.0–4.0 mm (0.079–0.157 in)
12. Install the coupling cover 6 and collar
7, and then tighten the bolt 8 to the
specified torque.
8
7
6
7
8
Coupling cover bolt 8:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
13. Connect the throttle cable 9 and choke
cable 0.
14. Check the throttle cable installation
length c and choke cable installation
length c is within specification, and then
tighten the nuts to the specified torque.
b