User's Reference; Printing At The Desired Location - Roland SolJet SJ-600 User Manual

User's Reference

Printing at the Desired Location

This sets the location where printing starts.
Normally the origin point is set at the lower-right point of the printing area.
When [SHEET TYPE] is set to [OPAQUE], the width of
the printing area is set automatically (see "User's Refer-
ence -- About the Printing Area").
To determine the desired printing area, follow the steps in
"Setting the printing area in the left-right direction (the
direction of carriage movement)" to set the width of the
printing area. When [SHEET TYPE] is set to [CLEAR],
the printing area is not set automatically, so set the
printing area in the same way. If this setting is not made,
the printing area uses the maximum value for the machine.
Canceling setup cancels the printing area.
To change the start point for printing, use the [BASE
POINT] key. At this time, the printing area does not
change.
Follow the step in both "Specifying a location in the
lengthwise direction" and "Specifying a location in the
left-right direction (the direction of carriage movement)"
to set the start point.
Left-hand edge of the printing area
Setting the printing area in the left-right direction (the direction of carriage movement)
Margin (value set for [PAGE MARGIN])
Starting location in the
lengthwise direction
"Specifying a location in
the lengthwise direction"
User's Reference
Right-hand edge of the printing area
Origin
Starting location in the left-right direction
"Specifying a location in the left-right direction (the
direction of carriage movement)"
Original printing
area
New printing
area
* Returning the
start point in
the left-right
direction to its
original
location
Printing area
49