Roland SolJet SJ-600 User Manual page 39

When sending a material-cutting command from the computer
to separate the material automatically
* When the material-cutting command has not been set to "enabled" at the computer, automatic separation of
the material is not performed, even when the following setting is made.
1
Press the [MENU] key and [
following screen appear on the display.
2
Press the [ ] key to make the following screen
appear on the display.
AUTO SHEET CUT
DISABLE DISABLE
3
Use the [ ] key to select [ENABLE], then press the
[ENTER] key.
AUTO SHEET CUT
DISABLE ENABLE
Attempting to return or cut off material that has not been allowed to dry sufficiently after printing may soil or damage
the printed surface. Make sure the printed surface has dried sufficiently before you return or cut off the material.
] key to make the
MENU
AUTO SHEET CUT
The material-separating location during
continuous output
Start of the next output
End of output
Location where separated
Margin (value set for [PAGE MARGIN])
Remove the Material
10 mm
(3/8 in.)
10 mm (3/8 in.)
37