About the Printing Area
The material's printable width (the direction of carriage movement) is determined by the width of the loaded material. When the
[SETUP] key is pressed after loading the material, the width of the material is detected and the printing area appears on the display. The
printing area is normally 10 mm (3/8 in.) inward from the respective left- and right-hand edges of the material.
When the printable width have been specified with the [PRINT AREA] menu, the margins are in accordance with these setting values.
Printing length
10 mm (3/8 in.)
Below are listed the widths of material that can be mounted on the SJ-600/500 and the printing widths of the
SJ-600/500.
-Acceptable material width
SJ-600: 210~1625 mm (8-5/14 ~ 64 in.)
SJ-500: 210~1371 mm (8-5/14 ~ 54 in.)
-Printing width
SJ-600: 210 ~ 1615 mm (8-5/14 ~ 63-9/16 in.)
SJ-500: 210 ~ 1361 mm (8-5/14 ~ 53-9/16 in.)
Printing width
10 mm (3/8 in.)
When the printable width have been specified with the [PRINT AREA] menu,
the margins are in accordance with these setting values.
60 mm (2-3/8 in.)
Material
Printing area
Origin (0, 0)
10 mm (3/8 in.)
User's Reference
59