Roland SolJet SJ-600 User Manual page 71

[INVALID SHEET] appears and the material cannot be detected even when
the [SETUP] key is pressed
If the material loaded on the unit is transparent, then at the [SHEET TYPE] menu, select [CLEAR].
1
Press the [MENU] key and [
following screen appear on the display.
3
Use the [ ] [ ] key to select [CLEAR], then press
the [ENTER] key.
SHEET TYPE
OPAQUE CLEAR
- When the setting for [SHEET TYPE] is changed after setup for
the material has been performed, the setup for the material is
automatically canceled. If this happens, set up the material
again.
- When using opaque material, return the [SHEET TYPE] setting
to [OPAQUE].
If the "INK EMPTY" message appears
A cartridge has run out of ink, and printing cannot be started.
If printing data is being sent, this message is displayed and the buzzer sounds. At the same time, operation is paused and the PAUSE
LED flashes. Replace the empty cartridge with a new one and press the [PAUSE] key to start printing.
Clean, attractive printing is impossible
If drop-out occurs with printed images.
Clean the printing heads (see "Maintenance -- Cleaning the Printing Heads").
Is the surface of the platen dirty or scratched?
Clean the platen (see "Maintenance -- When the Product Needs Cleaning").
Is the material dirty?
Remove superficial soiling, then load the material.
Is the material damaged?
Clean, attractive printing is not possible if the material is damaged or warped.
Use care to keep materials from being damaged while in storage.
] key to make the
MENU
SHEET TYPE
2 Press the [ ] key to make the following screen
appear on the display.
SHEET TYPE
OPAQUE OPAQUE
4 Specify a printing area for the left-right direction (the
direction of carriage movement) that matches the
width of the material. For more information, see "
User's Reference -- Printing at the Desired Location --
Setting the printing area in the left-right direction (the
direction of carriage movement)."
When [SHEET TYPE] has been set to
[CLEAR], no detection of the material is
performed when material is loaded. This
means it is necessary to specify a printing
area that matches the actual width of the
material.
When only set to [CLEAR], the printable
width is set to the maximum (SJ-600:1605
mm (63-3/16 in.), SJ-500:1351mm (53-3/
16 in.)).
What to Do If...
Continued on the next page.
69