Setting Up And Connection - Roland SolJet SJ-600 User Manual

What to Do upon Opening the Carton

3 Setting Up and Connection

Setting Up
Unpacking, installation, and moving
must be carried out by four or more
persons.
Otherwise the machine or the stand may
fall, resulting in injury.
NOTICE
Be sure to install the drain bottle before switching on the power.
Use in the following environment.
• Temperature: 15 to 35 ˚C (59 to 95 ˚F), humidity: 35 to 80 % (no condensation)
Also, take care to ensure that the following conditions are not exceeded even when the machine is not in opera-
tion. In particular, be careful to make sure not to expose the machine to high temperatures of 40 ˚C (104 ˚F) or
more.
• Temperature: 5 to 40 ˚C (41 to 104 ˚F), humidity: 20 to 80 % (no condensation)
Never install the unit in any of the following situations, as it could result in breakdown or faulty operation:
• Places where the installation surface is unstable or not level.
• Places with excessive electrical noise.
• Places with excessive humidity or dust.
• Places with poor ventilation, because the unit generates considerable heat during operation.
• Places with excessive vibration.
• Places exposed to strong illumination or direct sunlight.
Never step or stand on the stand legs, as doing so may damage them.
Do not place objects on the unit, as doing so may result in breakdown.
The required installation spaces for this model are listed below.
SJ-600: 3500 mm [W] x 2000 mm [D] x 1700 mm [H]
(137-13/16 in. [W] x 78-3/4 in. [D] x 66-15/16 in. [H])
SJ-500: 3300 mm [W] x 2000 mm [D] x 1700 mm [H]
(129-15/16 in. [W] x 78-3/4 in. [D] x 66-15/16 in. [H])
18
Install in a level and stable location.
Otherwise the unit may tip over and cause
injury.