Rack Mounting - Elan D12 Installation Manual

E L A N H O M E S Y S T E M S

Rack Mounting

When mounting the D12 in an equipment rack, use the included Rack Mount Brackets for secure mounting and
proper ventilation. The D12 requires three rack spaces.
To install the D12 into a standard 19" equipment rack:
1. Attach the rack mount bracket onto the D12 chassis from the front as shown in Figure C-1.
2. Ensure that the brackets are flush with the front of the unit. Install each of the eight screws (included) through
the side mounting flanges into the holes in the sides of the unit as shown in Figure C-2. Hand tighten screws!
Over-tightening could cause damage to the D12 Tuner.
3. Once the brackets are securely mounted, install the entire assembly into a standard 19" equipment rack from the
front using four rack screws (not included). Three rack spaces will be used. See Figure C-3.
© ELAN Home Systems 2009 • All rights reserved.
Figure C-1
Figure C-2
Rack Screws
Figure C-3
Rack Screws
19" Equipment Rack
D12
INSTALLATION MANUAL
Page 3