Channel Lock Menu; Ace Menu - Elan D12 Installation Manual

D12
INSTALLATION MANUAL
• Input 1 + 2 Mono Bus A: All channel's audio is the sum of audio input 1 and 2 (Mono) which is Bus A
• Input Direct: Audio Input 1 is routed to channel 1, Audio Input 2 is routed to channel 2, etc...Audio Input 12 is
routed to channel 12.
• Direct Mono: Audio Input 1 + 2 summed (Mono) is routed to channels 1 and 2, Audio Input 3 + 4 summed
(Mono) is routed to channels 3 and 4 etc... Audio Input 11 + 12 summed (Mono) is routed to channels 11 and 12,
Press the Channel button to change the channel.
Press UP and DOWN buttons to change the option.
Press the MENU button to cycle to the next menu.

Channel Lock Menu

This menu allows any or all channels to be locked or unlocked after initial set-up selections have been determined.
When locked, channel settings can not be altered even by IR Commands in ELAN mode.
IndIvidual channels 1 - 12 options are LOCKED or UNLOCKED.
All channel optons are MIXED, LOCKED, or UNLOCKED. MIXED means that some channels are locked and
some channels are not locked.
Press the Channel button to change the channel.
Press the UP and DOWN buttons to LOCK or UNLOCK the selected channel.
Press the MENU button to cycle to the next menu.

ACE Menu

When ACE (Automatic Clipping Eliminator) is set to ON, the amplified output is continuously monitored for signal
clipping. Extremely fast transients are ignored but if it sees a consistent clipping trend, it turns the respective chan-
nel down by one increment. This action is repeated until no more clipping is detected for five seconds. After 5 sec-
onds it gradually increases the gain of the channel back to its last setting.
ACE will be displayed on the Volume screen. See "Volume Menu" on page 6.
IndIvidual channels 1 - 12 options are ON or OFF.
Page 10
Channel Lock Menu
© ELAN Home Systems 2009 • All rights reserved.
E L A N H O M E S Y S T E M S