Appendix B: Rack Mounting - Elan A12 Installation Manual

A12
INSTALLATION MANUAL

Appendix B: Rack Mounting

RMK3 Rack-Mount Kit
When mounting the A12 amplifier in an equipment rack, use ELAN's RMK3 Rack Mount Kit for secure mounting and
proper ventilation. The RMK3 requires three rack spaces. To install the RMK3 into a standard 19" equipment rack:
1. Slide the rack mount kit onto the A12 chassis from the front as shown in Figure B-1.
2. Ensure that the unit is flush with the front of the mounting kit. Install each of the eight screws (included) through
the side mounting flanges into the holes in the sides of the unit as shown in Figure B-2. Hand tighten screws!
Over-tightening could cause damage to the A12 Amplifier.
3. Once the unit is securely mounted into the RMK3, install the entire assembly into a standard 19" equipment rack
from the front using four rack screws (not included) as shown in Figure B-3.
Page 26
Figure B-1
Figure B-2
19" Equipment Rack
Rack Screws
Figure B-3
© ELAN Home Systems 2009 • All rights reserved.
E L A N H O M E S Y S T E M S