Input Select Menu - Elan D12 Installation Manual

D12
INSTALLATION MANUAL
6. On the Volume screen, select the channel that is wired to the speaker where the person is listening.
7. Slowly adjust Volume Up for this channel until the audio begins to distort, then drop the level one or two per-
centages.
8. Follow this procedure for all channels to achieve a good balance of sound from the most used listening posi-
tion in the zone.
9. Enable or Disable ACE for all applicable channels. See "ACE Menu" on page 10
Note: High volume levels can cause clipping and distortion. This can damage the loudspeaker's components and
cause the amplifier to go into protection mode. The protection circuits will reset when the output signal conditions
have returned to normal. Overdriving the amplifier can damage the amplifier and void the manufacturer's warranty.

Input Select Menu

The INPUT SELECT menu will allow any or all of the D12's channels to be configured among six options:
This example is with Channel 1 selected.
• Input 1 Direct: This is the default, Channel's audio is taken from audio input 1
• Input 1 + 2 Mono Direct: Channel's audio is the sum of audio input 1 and 2 (Mono)
• Input 1 Bus A: Channel's audio is taken from audio input 1 which is Bus A
• Input 1 + 2 Mono Bus A: Channel's audio is the sum of audio input 1 and 2 (Mono) which is Bus A
• Input 7 Bus B: Channel's audio is taken from audio input 7 which is Bus B
• Input 7 + 8 Mono Bus B: Channel's audio is the sum of audio input 7 and 8 (Mono) which is Bus B
Notice that Input 1 Direct is audio input 1 which is the same as Input 1 Bus A. Also notice that Input 1 + 2
Mono Direct is audio input 1 and 2 summed which is the same as Input 1 + 2 Mono Bus A. This is because
the selected channel is channel 1. To help clarify this, see the next example with channel 5 selected.
Page 8
Channel 1 Selected
© ELAN Home Systems 2009 • All rights reserved.
E L A N H O M E S Y S T E M S