Single Stereo Input With Stereo Out On Channels 1 - 8 - Elan D12 Installation Manual

D12
E L A N H O M E S Y S T E M S
INSTALLATION MANUAL

Single Stereo Input with Stereo out on Channels 1 - 8

ELAN Legacy Standard application
This is how you would have set up ELAN's previous amplifiers. This is NOT how ELAN recommends utilizing the
D12. This is being shown to demonstrate the difference in legacy amplifiers and the D12. See "ELAN Special
Application" on page 39 to see how the D12 should be used for this application.
Prerequisites:
Factory defaulted
Normal or ELAN mode
See:
"Restore Defaults" on page 20
"Operating Mode" on page 13
This example displays a basic stereo setup. Stereo from a source device is connected to audio inputs 1 and 2.
Audio Inputs 1 and 2 buffered loop outputs are then connected to audio input 3 and 4. Audio Inputs 3 and 4 buff-
ered loop outputs are then connected to audio inputs 5 and 6. Audio Inputs 5 and 6 buffered loop outputs are then
connected to audio inputs 7 and 8.
Audio input 1 is routed to channel 1, audio input 2 is routed to channel 2, audio input 3 is routed to channel 3,
audio input 4 is routed to channel 4, audio input 5 is routed to channel 5, audio input 6 is routed to channel 6, audio
input 7 is routed to channel 7, and audio input 8 is routed to channel 8.
Volume is adjusted by the ELAN System Controller or by the other Audio Device. Increasing or decreasing the
volume increases stereo channels 1, 2, 3, 4, 5, 6, 7, and 8.
Page 38 © ELAN Home Systems 2009 • All rights reserved.