Table of Contents
Advertisement
Photon User Guide 412-0035-00-10 Version 100
follow the instructions with the device. If you are using custom cabling and/or interface
electronics, contact FLIR Systems Customer Support at (805) 964-9797 if you need additional
assistance.
1. Follow the steps shown in Section 6 for basic operation of the Photon camera. After
verifying that the camera is operating properly, disconnect power from the Interface
Module.
2. Connect the SIPO accessory module directly to the three-row DB15 connector on the
Interface Module labeled "DIGITAL DATA". (No cabling is required.)
3. Connect the parallel data cable to the mating connector on the SIPO module. Connect
the other end to the frame-grabber board installed in your PC.
Note: The parallel data cable is specific to a particular frame grabber. In other words, a
parallel data cable intended to mate to a Bitflow frame grabber will not mate with a
National Instruments frame grabber or vice versa.
4. Follow instructions included with the frame grabber for selecting the camera
configuration file included with the SIPO module.
5. Reapply power to the Interface Module. This will power-up both the Photon camera and
the SIPO module, and digital data will begin streaming.
6. If desired, change the digital data mode using the Control Panel software (see Section
7.1.1).
9 PHOTON PHYSICAL INTERFACE
Dimensioned Drawings
A dimensional drawing for each lens configuration is shown in Table 9 . The Table 9 also shows
a list of corresponding ICDs or Interface Control Documents of the Photon camera in the 14.25
mm, 19 mm, 30 mm, 35 mm and 50 mm lens configurations, respectively.
Figure Number
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
Weight
Below in Table 10 are the combined weight of the Photon Camera core and the lens.
Table 9: Photon Lens Configurations
Nominal focal length
14.25 mm
19 mm
30 mm
35 mm
50 mm
30
ICD
102-1239-78
102-1239-77
102-1239-78
102-1239-80
102-1239-83
Advertisement
Table of Contents
