FLIR Photon Block 2 User Manual page 7

Photon User Guide 412-0035-00-10 Version 100
The Photon camera provides all input/output signals via a single 30-pin SAMTEC TFML-115-
02-S-D-P connector (J1) with pin definitions as shown in Table 2 The signals on this connector
include input power, analog video output, serial communication channel for command and
control, external sync, voltage output, I/O pins and the digital data output.
Table 2: 30-pin Power Board to External I/O Connector Pin Definitions
Pin # Signal Name
1,2,5,6
3
4
7
8
9
10
11
12
13 LVDS_VID2+
14
15 LVDS_VID2-
16 SD_ DATA+
17 LVDS_VID1+
18 SD_FSYNC-
19 LVDS_VID1-
20 SD_ FSYNC+
21 LVDS_VID0+
22
23 LVDS_VID0-
24
25
26
27
28
29
30
Note: The mating connector is SAMTEC SFML-115-T1-S-D-K
30
29
Figure 5: 30-pin SAMTEC (M) connector on camera
Note: See the Electrical Interface Control Document (ISC doc. 102-1238-41) for detailed interface
requirements. Pin-out definitions for the I/O Module are provided in Appendix A.
GND Ground
3.15V_OUT 3.15V output
PWR_IN Input voltage
1.5V_OUT 1.5V output
LIN Do not connect
RX2 Spare Serial Communication receive
RX Primary Serial Communication receive
TX2 Spare Serial Communication transmit
TX Primary Serial Communication transmit
Digital Port 2 Output Data, positive output
SD_DATA- Digital Port 1 Output Data, negative output
Digital Port 2 Output Data, negative output
Digital Port 1 Output Data, positive output
Digital Port 2 Sync, positive output
Digital Port 1 Sync, negative output
Digital Port 2 Sync, negative output
Digital Port 1 Sync, positive output
Digital Port 2 Clock, positive output
SD_CLK- Digital Port 1 Clock, negative output
Digital Port 2 Clock, negative output
SD_ CLK+ Digital Port 1 Clock, positive output
TEMP2 Temp Sensor port 2
DIS0_EXT External Sync
DIS2_EXT Discrete Input Channel 2
VIDEO_LO Analog Video, negative output
DIS1_EXT Discrete Input, Channel 1
VIDEO_HI Analog Video, positive output
7
Signal Definition
2
4
3 1