Time Code Section - Panasonic AG-HPX500P Operating Instructions Manual

Time Code Section

2
1 3
GENLOCK IN connector (BNC)
1
This connector is used to input a reference signal
before the camera unit is gen-locked, or before
the time code is externally locked.
TC IN connector (BNC)
2
This connector is used to input a reference time
code when you externally lock the time code.
TC OUT connector (BNC)
3
When you inter-lock the time code of the AG-
HPX500P/E with that of an external device this
must be connected with the time code input (TC
IN) connector of the external device.
HOLD button
4
Pressing this button freezes the time data
indication on the counter. Note that time code
generation continues. Pressing the button again
reactivates the counter.
This function is used to ascertain the time code or
CTL count of a particular recorded scene.
RESET button
5
Use this button to reset the counter value on the
time code display to 00:00:00.
When the TCG switch is positioned at [SET] and
the setting menus TC PRESET screen and UB
PRESET screen are open, press this button to
reset all set values to 0 and press the SET button
to preset.
4 6
7
COUNTER (counter display selector)
6
button
The LCD monitor and the viewfinder show the
counter value, time code, user bit and frame rate
data depending on how this switch and the TCG
switch are set.
TCG (time code selector) switch
7
This switch is used to specify the stepping mode
for the built-in time code generator.
Select this position to continuously
advance the time code independently of
the P2 card recording status. Use this
F-RUN
mode to synchronise the time code with
the time of day, or to externally lock the
time code.
Select this position to set the time code
SET
and/or user bits.
Select this position to advance the time
code only during recording. The time code
is continuously recorded during normal
recording. But deleting clips and continue
R-RUN
recording of clips at a frame rate of 24P
or 24PA that have been recorded at any
other frame rate may break the sequence
of time code recording.
CURSOR and SET buttons
8
Use these buttons to set the time code and user
bits.
The four triangular buttons are the CURSOR
buttons, and the center rectangular one is the
SET button.
For guidance in setting the time code and user
bits, see [Setting Time Data].
5
8
25