Panasonic AG-HPX500P Operating Instructions Manual page 79

5
Select YES using the JOG dial button,
and press the JOG dial button.
• In the following example, TITLE 1 is the
filename.
• When writing is completed, WRITE OK
appears.
SCENE FILE (SD CARD)
WRITE FILE 1
YES
TITLE EDIT
TITLE 1
SEL : PUSH FF/REW
PUSH MENU TO RETURN
6
Press the MENU button to cancel the
menu mode.
To load a file
Perform steps 1 to 3, select READ in step 4, and press
the JOG dial button.
When reading is completed, READ OK appears.
PUSH STILL
To title a file
1
Perform steps 1 to 4.
2
Use the JOG dial button to select
characters, then press the JOG dial
button to move to the next character.
• You can input any of the following characters:
Space, A to Z, 0 to 9, : ; < = > ? @ [ \ ] ^_-./
• You can erase all characters using the
RESET button.
3
After entering all the characters, press
the cursor button at the left end of the
characters, and then press the JOG dial
button.
<Note>
• If WRITE NG FORMAT ERROR appears, format the SD
memory card.
• If WRITE NG WRITE PROTECT appears, release the
protected status of the SD memory card.
• If WRITE NG CANNOT ACCESS appears, quit all other
operations (such as playback) before proceeding.
• If WRITE NG ERROR appears, the SD memory card may
be defective. Replace it.
79
Handling setup data