Connecting The Aj-Rc10G Extension Controller - Panasonic AG-HPX500P Operating Instructions Manual

Connecting the AJ-RC10G Extension
Controller
• Some functions can be remote-controlled when
the AJ-RC10G extension control unit (optional) is
connected to the camera.
• When the AJ-RC10G is connected, the camera
automatically enters remote control mode after the
power switches of both the camera and the AJ-
RC10G are turned ON.
REMOTE connector
<Notes>
• Be sure to turn OFF both the camera and the AJ-RC10G
power switches before connecting or disconnecting
the controller cable.
• If ECU DATA SAVE is set to OFF, the camera-related
setting values, which have been adjusted or set using
the AJ-RC10G, will be cancelled when the camera
power switch is turned OFF. Also, the setting values
cannot be written to an SD memory card. However, the
menu settings performed using the AJ-RC10G can be
written to an SD memory card. Next time the AJ-RC10G
is connected, the setting values will return to the AJ-
RC10G settings.
ECU DATA SAVE can be selected from the <SW MODE>
screen on the CAM OPERATION page.
• If ECU DATA SAVE is set to ON, the values adjusted or
set using the AJ-RC10G are retained, even after the
camera power switch is turned OFF.
• The USER switch on the camera does not function
when the AJ-RC10G is connected.
• When controlling the shutter from the AJ-RC10G, the
shutter speeds correspond to the speeds set by the
menu on the camera, not the speeds written on the AJ-
RC10G. The shutter speeds correspond as follows:
AJ-RC10G
Shutter Speed Indication
100 (60)
120
250
500
1000
2000
AJ-RC10G
Camera Shutter
Speeds
POSITION1
POSITION2
POSITION3
POSITION4
POSITION5
POSITION6

Connecting the AJ-RC10G Extension Controller

93