Panasonic AG-HPX500P Operating Instructions Manual page 130

Inspection of the clock, time code, and
user bits
1
Set the user bits as required.
Please refer to [Setting the User Bits] for the
setting procedures.
2
Set the time code.
Please refer to [Setting the Time Code] for the
setting procedures.
3
Set the TCG switch to [R-RUN].
• Press the COUNTER button to display the
time code on the LCD monitor or in the
viewfinder.
4
Press the REC START/STOP button.
• Check that the counter display number
changes as recording progresses.
5
Press the REC START/STOP button
again.
• Check that recording stops and the counter
display number stops changing.
6
Set the TCG switch to [F-RUN].
• Check that the counter display number
changes regardless of recording status.
7
Hold down the DISP/MODE CHECK
button to check the date and time on
the LCD monitor or in the viewfinder.
• Adjust the date and time setting if the DATE,
TIME and time zone is not correctly displayed.
For details, see [Setting Date and Time of
Internal Clock].
<Note>
Note that date and time data set for DATE, TIME,
and time zone is recorded in clips, and affects
the playback sequence, etc. at the time of
thumbnail manipulations.
130
Inspections Before Shooting