Selecting Mcr Mode Recording And Playback Signals; Selecting Video Output - Panasonic AG-HPX500P Operating Instructions Manual

Selecting MCR mode
recording and playback
signals
MCR mode allows you to record signals from the 1394
connector and play back P2 card clips.
Use the setting menus listed below to select recording
or playback signals.
Setting menu
Set system frequency.
(59.94 Hz, 50 Hz) When this
SYSTEM FREQ setting is changed, wait for
(OTHER FUNCTIONS the "TURN POWER OFF"
screen) message to appear to turn
the power off and then turn it
back on again.
●Select the format for
●Recording and playback of
MCR FORMAT
(RECORDING SETUP ●720P/30PN, 720P/24PN
screen)
●In a change from CAMERA
●In SD mode (480i, 576i),
480i (576i) MCR MODE
(RECORDING SETUP
screen)
●In a change from CAMERA
Setting
recording signals input
to the 1394 connector or
format for playing back P2
card clips.
1080i, 720P and 480i/576i
are possible.
and 720P/25PN enable
playback of clips recorded
at respective native frame
rate.
MODE to MCR mode, the
REC FORMAT recording
format is retained.
you can select DVCPRO50,
DVCPRO or DV for
recording 1394 connector
signals or as playback
mode to play back P2 card
clips.
MODE to MCR mode, the
480i (576i) REC MODE
takes over.

Selecting video output

CAMERA MODE and MCR mode allow you to select
video output format.
Use the setting menus listed below to select video
output.
Setting menu
Select the signal format
(720P, 1080i, 480i/576i)
CMPNT/SDI SEL to be output from the
(OUTPUT SEL screen) COMPONENT OUT
connector and SDI OUT
connector.
Select the setup level for the
480i video signal.
●7.5%: 7.5% setup level
SETUP
(CAMERA SETUP screen)
●0%: Setup 0% also for
Select the screen type to
be output (COMPONENT
OUT, SDI OUT when VIDEO
DOWNCON MODE
OUT and CMPNT/SDI SEL
(DISPLAY SETUP screen)
is down converted to 480i or
576i) and down-converted in
HD mode (1080i, 720P).
<Note>
The audio and video may be disturbed when the
REC FORMAT and MCR FORMAT is changed in the
setting menu SYSTEM FREQ, but this is not a camera
malfunction.
Setting
for output only (0% for
recording)
output and recording
45
Video and recording formats