White Balance - Panasonic AG-HPX500P Operating Instructions Manual

7
The adjustment will take effect in a few
seconds, and the following message
will appear:
• The adjusted value is automatically stored in
the selected memory (A or B).
8
If the subject's colour temperature is
lower than 2300K or higher than 9900K
the following message appears:
• If the arrow points down (↓) the actual colour
temperature is lower than the temperature
indicated. If the arrow points up (↑) the actual
temperature is higher than the temperature
indicated.
When you have no time to adjust the

white balance

Position the WHITE BAL switch at [PRST].
When the white balance has not been
automatically adjusted
When the white balance has not been successfully
adjusted, the viewfinder displays an error message.
If one of the error messages listed below appears,
take the appropriate steps, then adjust the white
balance again.
If the error message appears after repeated
readjustments, the interior of the unit must be
inspected. For more information, contact your
distributor.
Error message Description
The colour
AWB NG temperature is
too high.
The colour
AWB NG temperature is
too low.
There is
LOW LIGHT insufficient
light.
There is too
LEVEL OVER
much light.
The FILTER
CHECK FILTER control is
displaced.
50
Adjusting the White balance and Black Balance
AWB Ach OK 3.2K
AWB Ach OK 2.3K
Remedies
Select an appropriate
filter.
Select an appropriate
filter.
Increase the light
level or gain.
Decrease the light
level or gain.
Check the FILTER
control.
Error message Description
AWB was not
completed
TIME OVER
within the time
allowed.
Viewfinder displays related to white
balance
See [Viewfinder Screen Status Displays].
Remedies
Shooting conditions
may be unstable.
If flicker occurs,
press the shutter
and readjust the
AWB under stable
conditions.