Panasonic AG-HPX500P Operating Instructions Manual page 133

LCD or
Warning
Priority viewfinder
type
indication
The last bar in
the battery level
Battery
indication blinks
8 nearly
(not if indications
empty
have been turned
off by the menu)
P2 card
The P2CARD
nearly
9 level indicator
fully
blinks.
recorded
* P2 SYSTEM ERROR cause indication
1
• P2 MICON ERROR: The P2 microprocessor does not respond
• P2 CONTROL ERROR: A P2 recording error has occurred
• REC RAM OVERFLOW: Overflow of recording RAM
* REC WARNING causes
2
• CARD ERROR*: P2CARD error (* indicates the number of the slot of the card with the error)
• ERROR: Other recording errors
* 3 In a transition from thumbnail display to recording, a further transition is made to CAMERA mode where a warning is output.
Perform either of the following procedures to cancel this warning.
• Press a playback control button.
• Press the MODE (CAMERA/MCR/PC) button.
• Remove the P2 card and insert another card.
* Perform either of the following procedures to cancel this warning.
4
• Press the REC START button.
• Press a playback control button.
• Press the MODE (CAMERA/MCR/PC) button.
• Remove all cards.
* When NEAR END CANCEL is set to ON, you can press the DISP/MODE CHECK button to cancel the alarm.
5
* When the alarm sounds, audio is not output to the camera speakers or headphones. The DISP/MODE CHECK button cancels
6
only the alarm tone when pressed during an alarm.
Viewfinder
Tally Warning
LED
lamp lamp
(except tally)
The BATT
LED blinks
(during
recording, the
BATT LED Blinks 1 Blinks 1
and the tally time per time per
LED blink second second
alternately;
during pause,
both LEDs
blink.)
When SAVE
Blinks 1 Blinks 1
LED is set to
time per time per
P2CARD, the
second second
SAVE LED
during during
blinks 1 time
recording. recording.
per second.
Warning description
Alarm
and recording/
tone *
6
playback operation
The battery is near
No depletion. Operation
continues. * 5
Less than 2 minutes
is left on the P2 cards
(level indicator shows
No
1 minute or less).
This warning appears
only during recording.
Countermeasures
Replace the battery
as necessary.
Replace or insert
additional P2 cards.
133
Warning System