Reloading From A Dat - Akai DPS16 Operator's Manual

Chapter 10: Project Management (Project Mode)

Reloading from a DAT

1. Use the digital audio COAXIAL cable (that you used for backup) to connect the DIGITAL IN jack on
the rear panel of the DPS16 and the digital output jack on the DAT recorder.
2. On the Project screen, press the [F1] (
3. Set the Device field to "
The following screen appears.
Press the
[F6]
The following screen appears and the DPS16 waits for a signal from the DAT recorder.
4. Play the DAT tape that contains the backup data.
When the DPS16 starts receiving data from the DAT recorder, it displays the following screen.
1 Displays the name of the Project being reloaded.
When the reload operation is completed, the display returns to the Project screen.
Press the
CAUTION :
is transmitted as a digital signal, an attempt to monitor it may damage the speakers.
124
DIGITAL IN
DPS16
".
DAT
( DO IT ) key.
( CANCEL ) key to cancel the reload operation.
[F1]
Do not monitor the audio via the DAT during the reload operation. Since audio and other data
COAXIAL cable
JOG SHUTTLE
) key followed by the [F5] (
MORE
DIGITAL OUT
DAT
) key.
RELOAD